Bubble Test was created to facilitate running tests in duplicate, primarily created for inhibitors, it is perfectly suitable for testing in stationary cells, flow loops, autoclaves and any other metal/electrolyte situation. 

A series of LPR tests are collected over time, giving Corrosion Rate results. Cells (or Channels) are assigned together into Groups, each group has an Add Inhibitor button, once pressed, corrosion rates can be calculated for 3 periods – prior to Add Inhibitor, after 2 hours and after 16 hours (configurable), this enables Percentage Protection to be calculated.

The philosophy behind this software was simplicity and ease of use, five simple steps are all it takes to set up a new test, all handled through a wizard process:

Finally at the end of testing a Cyclic Voltammetry Sweep can be performed. Results can be printed at the end in many ways including tables, lines and bar graphs allowing any untrained operator to produce very technical reports on the performance of inhibited systems.

Bubble Test Software Manual     pdf     word doc